Walk In Freezer Installation Guide

Check overhead for anything that could cause a safety hazard electrical wires utility lines air ducting or any other obstructions.

Walk in freezer installation guide.

Indoor or outdoor walk in cooler. High temperature walk in cooler. On floorless walk ins work panels into pre installed screeding. These steps are necessary to keep your walk in level square.

Walk in installation operation maintenance warranty manual job name serial number. 2 walk in cooler freezer application. Walk in coolers can be setup indoors or outside. On floored units place male bottom of wall panel in female groove of floor panel.

The floor area that the walk in is to be installed on must be clear of all moisture dirt and debris. Once panel is inserted correctly install w2 wall panel with w1 panel male edge will be inserted into female edge of w2 panel. For outdoor installation the unit. Medium temperature walk in freezer.

The first step is to install the base channel which is attached directly to the floor with concrete anchors. Breaker strips thermal breaks are used to prevent heat transfer between the cooled side and the ambient side of a concrete floor. Walk in cooler walk in freezer buying guide walk in refrigerator walk in freezer or combo unit. A minimum of 2 clearance above the walk in is recommended to install the walk in.

The types of screeds furnished with your unit will be identified on the unit assembly drawing. If screed was ordered with your cooler this should be laid out first. The installer must determine the best and safest way to get the panels to the installation site without damage or bodily injury. Do not set a cooler thermostat below the walk ins design temperature or product freezing or excessive evaporator coil icing may result.

Walk in cooler installation steps. The walk in coolers are walk in freezers are used in a variety of temperature ranges. Make sure the floor arrow on the wall panel is pointing down. Always have a competent.

Used for holding meats seafood and stuff that needs the same temperature. Walk ins installed near existing building walls must be positioned with a minimum 2 clearance to allow for air circulation and prevent possible condensation on the exterior surface of the panels. Used for holding fruits vegetables eggs medicine and wood. When placing walk in adjacent to building wall s allow 2 minimum clearance on all sides to allow for circulation and to prevent possible condensation on the exterior surface of the walk in.

Screed identification and installation there are many styles of screeds used in floorless walk in coolers and freezers. General information section 2.